For design purposes, temperature, steam to biomass ratio (SBR) and the type of biomass were selected as input factors.
Continuous temperature measurements were made as soon as possible in the commencement of therapeutic cooling with a bladder-temperature probe (Foley catheter temperature sensor; Smiths Medical, Dublin, OH, USA) and with a general-purpose temperature probe (Mon-a-therm General purpose; Mallinckrodt Medical Inc., now part of Covidien, Hazelwood, MO, USA) inserted in the esophagus.
For this purpose, as indoor design temperature is increasing from 18 to 26 °C, the transmission loads are calculated using an implicit finite difference method under steady periodic conditions.
For this purpose, high temperature oxidation tests were conducted at three temperatures (500, 600 and 700 °C) in air and for up to 96 h.
For this purpose body temperature and weight were measured immediately before treatment and body temperature was measured again 4 h post-injection.
For this purpose, four temperature sensors are mounted on the APDv board.
For this purpose, high temperature low cycle fatigue tests were performed in both the absence and presence of mechanical cycling.
The museum-quality cars are kept in a purpose-built, temperature controlled environment which is prepaid for by money raised in each offering.
For the purposes of temperature preconditioning, myocytes were temperature preconditioned before being placed in the chamber.
For the purposes of temperature preconditioning, isolated ventricular myocytes in Tyrode solution (approximately 0.4 million cells/ml) was placed in a water bath to reach a final temperature of 16 °C for a 2-min period.
