At the same time, with the purpose of minimising displacement, another objective function, termed volumetric displacement, has been defined.
Therefore, the purpose of oil displacement during polymer flooding is to improve the macroscopic and microscopic displacement efficiency to improve oil recovery (Romero-Zeron 2012).
The focus of this study is on the design, theory analysis, and optimization of amplifiers, not only with the purpose of providing a larger displacement output, but also achieving micro-vibration isolation in desired frequency band.
For the purpose of enlarging the micro displacement generated by the ultrasonic vibration and obtaining a large torque and a higher efficiency, the resonance frequency of the longitudinal vibration and torsional vibration should coincide.
Within each sex and temperature, principal component analyses [ 41] of the VCV matrices were performed for each source of variation with the purpose of describing the landmark displacements corresponding to each emerging principal component (PC), and also to test for the congruence of these displacements between effects.
For this purpose, a 3D vector field, a set of displacement vectors, is constructed based on the given constraints.
I could write for hours about the idea of displacement of possibility and purpose, but I will allow you to draw your own conclusions on this subject.
In this paper, the characterization of the schematized response spectra has been deeply investigated with the purpose of obtaining a more accurate displacement design spectrum and a simple but efficient criterion for the selection of recorded ground motions.
The purpose of back-analysing the measured displacements of the tunnel perimeter and the loads on the support structures during the construction of the work is to calibrate the initial estimations of the geomechanical parameters of the ground.
Peer reviewed journal publications were not included in the desk review because it was anticipated that few, if any, studies with primary data focusing on internal displacement in Syria would be identified; furthermore, the time delay associated with peer review publication would render any existing studies outdated for the purposes of estimating current displacement.
From an optimizing point of view, the model with the new moving boundary is more suitable than the conventional models for design purposes because the displacement magnitude of the horn tip is the only fitting parameter.
