For that purpose, concentrations were chosen that resulted in a viability decline of roughly 10, 40, and 60%%.
For this purpose, concentrations of APPs were determined in the BALF of C. psittaci inoculated calves at three time points after inoculation.
For computational purposes, concentrations at t = −15 min were taken as concentration at zero time.
For statistical purposes, concentrations below LOQ were replaced with f × LOQ, with f being the fraction of samples above LOQ.
For this purpose, the concentration of SA in gelation and washing solution was determined spectrophotometrically at 359 nm.
For this purpose, the concentration of the developed inhibitor in the formation water was determined based on the reaction of the ions with molybdate in an acid medium (MacAdam and Parsons 2004).
For the comparison purpose, the concentration changes of MB solution were also investigated with the same experimental setup in the absence of ZnO micro-tubes and under UV light illumination, or with the presence of ZnO micro-tubes and no UV illumination.
Some results of the application of ERT to milk mixing/holding tanks and milk flow pipelines for the purpose of concentration and composition measurements, detection of abnormalities and faults, and multidimensional flow and velocity profile measurements have also been presented as a case study of using this taxonomy.
For calculation purposes, higher concentration (μg/ml) of each concentration range was used for FE determination (e.g., 64 from 32 - 64 μg/ml).
For this purpose, the concentrations of different salts including NaCl, KCl, CaCl2 and MgCl2 are examined during 10 days of soaking for salts concentrations range of 0 45,000 ppm.
This opinion comes to the conclusion that measuring degradation at 20 °C has several advantages over lower temperatures in the light of accuracy and uncertainty as well as the regulatory purpose: (1) Concentrations of metabolites/transformation products are higher and thus are identified with higher accuracy.
