Sentence examples for pulse spectrum from inspiring English sources

In [17] the authors evaluate the range error of a pulsed UWB system, concluding that accuracy at longer distance depends on pulse spectrum and that short transmit pulses are necessary in dense multipath environment to maintain accuracy.

The SPM technique uses the broadening of the pulse spectrum.

Correspondingly, in the frequency domain, the initial first-order phase modulation can make the pulse spectrum exhibit red-shifting or blue-shifting phenomenon with the pulse spectrum profile and its breather evolution behavior unchanged.

Indeed, in line with [12], the wider the pulse spectrum is, the severer the ICI will be resulted.

The amplifier gain, output energy stability, amplified spontaneous emission (ASE) level, amplification time, and output pulse spectrum have been measured for different seed pulse energies and pump levels.

This means that if the pulse spectrum is band-limited to the extended subcarrier spacing, no interference exists between the subcarriers.

One pulse spectra were measured with a 1.0 μs pulse length (corresponding to a 20 degree tip angle) and a relaxation delay of 5.0 s (silicon) or 10 s (carbon) for 16,000 to 29,000 acquisitions while spinning at typically 5.0 kHz.

If λ2≫, λ2 can be estimated from the line width of pulse spectra recorded during early stages of the hyperpolarization build-up.

At each combination of tuning and matching positions thus adjusted, a spin noise spectrum was recorded using the block wise pseudo-2D method described previously.[ 8] Before changing the tuning and matching settings the reference pulse spectra were acquired (the amplifier cables had to be de- and reconnected for each of these steps).

In addition, the build-up time constants for the positive and negative polarizations were determined to be 71 s and 114 s, respectively, from the line widths in small flip angle pulse spectra during microwave irradiation following the approach by Desvaux et al.[ 10] Spin noise data in this communication were always recorded more than 600 s after the last rf-pulse applied to the sample.

The signal spectrum and cancelling-pulse spectrum are demonstrated in Figure 13.