Sentence examples for protect layer from inspiring English sources
The deposition of FTO as a protect layer of fuel cell electrode after mild plasma pre-treatment improved the electrochemical stability.
Electrochemical impedance (EIS) data and open-circuit voltage decay (OCVD) data indicate that the electron lifetime is improved by co-adsorption of 3-phenyl-2,4-pentanedione, it is associated with the 3-phenyl-2,4-pentanedione co-adsorbent forms a protect layer of TiO2 which can inhibit the electron recombination efficiently.
Therefore, to recover layered data stream progressively from Layer 1 to Layer L, we can make k 1 ∗ ≤ k 2 ∗ ≤ ⋯ ≤ k L ∗. From Equation (1), we know that it can be also represented by r1≤r2≤⋯≤r L. So we can protect Layer i by assigning suitable r i, expecting to recover it after receiving r i ratio of output symbols.
Coal pillar decreases protected layer overall deformation, not just reduce deformation of coal pillar affected zone.
The protected layer evolutional characteristics of vertical stress, vertical displacement and pressure relief affection which coal pillar affected were analyzed.
Finally it is shown that polypyrrole acts as a protecting layer against carbon nanotube dispersion when sonicated in ethanol.
The area-specific resistance of the separator coated with the thin protecting layer and the rib layer was less than 13.8 mΩ cm2.
The robustness of brush films in such environments can be greatly improved by applying a hydrophobic, "protecting" layer between the supporting substrate and the interfacial, biopassive brush.
The addition of BFRP protecting layer is also proved to be an effective way to enhance the resistance of GFRP bars to the chemical attacks.
When coating acrylic resin on NCP, the solution of acrylic resin was filled into nanostructured architectures of the NCP to form a protecting layer on its surface, resulting in better tensile strength and Young's modulus of NCP-based substrate.
Moreover, the combination of the composition control with the introduction of both a ZnO compact layer (CL) and a TiO2 protecting layer (PL) was simultaneously integrated into one photoanode film for the first time.
