Sentence examples for proper solidification from inspiring English sources

The rules of casting design are intended to ensure a satisfactory flow of the metal in the mould, proper solidification, proper filling for soundness, and consistent mechanical properties, and to prevent the formation of surface anomalies and structure that might lead to localized corrosion.

The above primary emulsion was poured into 75 mL of ice-cold water (2 3 °C) containing surfactant (1.5 1.625% w/ v) and stirred to extract the organic solvent into the continuous phase and for proper solidification of SLNs.

Finally the low-(Al, Nb) TiAl Nb alloy with the fully β solidification is proper for the favorable mechanical property due to its homogeneous microstructure with the weak solute segregation.

The air-gap nucleation time, the stress evolution and the solid-shell growth pattern are examined for different mold topographies to illustrate the potential control of Aluminum cast surface morphologies during the early stages of solidification using proper design of mold topographies.

This study mainly aims to identify the roles that the nanoparticles and ultrasound may play in water solidification and determine the proper nucleation method and corresponding control conditions that can meet the requirements of low supercooling degree and good suspension stability simultaneously.

Thus a proper control over the cooling rate during solidification of ZA8 alloy by judicious selection of process parameter would yield better metallurgical and mechanical properties.

The formation of the favorable multi-phase multi-modal structure can be achieved by proper alloy selection and by controlling the solidification process.

This work has demonstrated that a forced intense melt flow combined with proper cooling conditions can greatly change the solidification structure of alloys, which is beneficial to microstructure control.

Proper cooling temperature should be maintained for the solidification and smooth finish of the pipe at the die head.

Simulation results reveal that castings do not experience sequential solidification, so the design is not proper for the exhaust valve.

Their filling and solidification characteristics were calculated in order to propose the proper overflow position.