Sentence examples for production flow rate from inspiring English sources

They showed that, as the production flow rate increases the product purity decreases; as the production step time increases the product purity reduces while its recovery increases.

A mathematical model that takes into consideration water temperature, production flow rate and plant design is presented.

Operation at a low pressure setpoint is desirable since it corresponds to a high production flow rate.

Production flow rate, specific heat capacity (SHC) of produced fluids, thermal conductivity (TC) and viscosity of annular fluids, Joule-Thomson effect on produced fluids, radius of wellbores, annular clearance, inclinations and production time are some of the parameters playing an important role in the heat transfer across the wellbore between produced fluids and formations.

Thus, given a defined frequency in the variable speed drive, the motor temperature was determined as a result of the equilibrium between the heat generation, calculated from the power that the pump demands from the motor, and the heat extraction resistance, calculated from the production flow rate around the motor.

Production flow rate (Mscf/D).

Figure 6 shows the required variations of the mean injection and production flow rates to achieve the shown optimized sweep efficiency.

Economic feasibility of an EGS reservoir cannot be ensured unless the production flow rates are sufficiently high enough (Tester et al. 2006).

Open image in new window Fig. 11 Water saturation profile at different stages of the water flooding process for a U-shaped obstacle (h 2/Y = 0.4; f = 15 days; d/X = 2/14) Open image in new window Fig. 12 Optimal injection and production flow rates for a U-shaped obstacle (h 2/Y = 0.4; f = 15 days; d/X = 2/14).

Open image in new window Fig. 5 Water saturation profile at different stages of the water flooding process (aspect ratio, h 2/Y = 0.375, frequency of measurements, f = 15 days, distance of obstacle, d/X = 2/14) Open image in new window Fig. 6 Optimal injection and production flow rates (h 2/Y = 0.375, f = 15 days, d/X = 2/14).

It is well noted that the employed optimization scheme enhances the sweep efficiency before the obstruction at breakthrough by approximately 55%%. Figure 12 also shows the required variations of the mean injection and production flow rates to achieve the shown optimized sweep efficiency.