Sentence examples for processing of electrical from inspiring English sources

This makes the estimation and further processing of electrical power system parameters an essential feature of the power system analysis [29].

The obtained results show the usefulness of the digital signal processing techniques for the processing of electrical signals received from PVDF transducers under deformation and the validity of this method of measuring the weight of moving vehicles.

Our experimental data show stable (in regards to birefringence drift) QKD over 1550 nm SMF telecom networks in Sagnac configuration, using the BB84-protocol [C.H. Bennett, G. Brassard, in: Proceedings of the IEEE International Conference on Computers, Systems, and Signal Processing, Institute of Electrical and Electronic Engineers, New York, 1984, p. 175] with phase encoding.

The current study gives evidence that the COMT Val158Met and the BDNF Val66Met polymorphisms influence the cortical processing of experimental electrical pain stimuli, however not in a direct manner but rather under moderation of the presence of chronic pain complaints.

Second, we did not collect subjective pain ratings, which may have affected relative depth of processing of the electrical and visual stimuli or amount of attention paid to these two modalities.

The reported power figures demonstrate the usability of the MPSoC paradigm within the processing of bio-electrical signals and show the benefits achievable by the exploitation of the instruction-level parallelism within tasks.

Processes were developed for specific mineral ores and deserve consequent modifications to be adapted to the recovery of metals from complex mixtures, arising eg from the hydrometallurgical processing of waste of electrical and electronic equipment (WEEE), as these mixtures contain a large panel of elements in highly fluctuating content.

The main industries are food processing and the manufacture of electrical appliances, textiles, paper, and lumber.

In industry, major activities include printing and publishing; food processing; and the manufacturing of electrical and electronic goods, automobiles, pharmaceuticals, and mechanical products.

In the case of electrical processing, scanning was performed by tip sliding with voltages of 0.5, 1.0, 1.5, 2.0, 2.5, 3.0, 3.5, 4.0, and 4.5 V as shown in Figure 1b.

Using the results, we used sequential electrical and mechanical processing to realize the change of electrical resistance due to the formation and removal of the oxide layer.