Sentence examples for procedures of metal from inspiring English sources

Classical physicochemical synthetic procedures of metal nanoparticles suffer from drawbacks such as polydispersity, low yield [ 1], and use of toxic reagents [ 2].

Qu and Dai [30] reported a substrate enhanced electroless deposition (SEED) procedure of metal nanoparticles on carbon nanotubes.

Metals can be removed from solution only when they are aptly immobilized, the procedure of metal removal from aqueous solutions often leading to effectively concentrating the metal.

In this regard, the utilization of appropriate substrate material in the synthesis procedure of metal oxide nanoparticles can prevent agglomeration, decrease the diameter of nanoparticles, and change the cluster-like morphology of nanoparticles to a powdered morphology.

An intelligent system for supporting the whole design procedure of metal forming processes has been developed by integrating the expert systems, the FEA programs and the CAD interface modules.

Surgeons at Rush University Medical Center have performed about two dozen replacement procedures because of metal debris over the last year, said Dr. Joshua J. Jacobs, the head the orthopedic surgery department there.

These procedures reduce the concentration of metal ions to approximately 50 ppm Mg and Ca [ 13].

A theoretical procedure for dynamic response of metal foam core sandwich beams struck by a heavy mass with low-velocity is developed to consider the combined local denting and global deformation.

In this article a step by step procedure for the preparation of metal matrix composite from waste polymer-based sacrificial rapid pattern via investment casting route has been outlined as a case study of aluminum matrix reinforced with SiC and Al2O3 particles.

Standard procedures of critical point and metal coating were done at Instituto de Biociências da Universidade de São Paulo.

In this paper, a non-linear procedure for the seismic design of metal connections in cross-laminated timber (CLT) walls subjected to bending and axial force is presented.