Sentence examples for procedures and b from inspiring English sources

The methods are subsequently classified into two groups: (A) approaches aiming to substitute elaborate sample pretreatment, separation and pre-concentration procedures by simplified procedures and (B) approaches providing enhanced detection techniques with regard to fast signal read-out, miniaturised instrumentation and, simultaneously, high sensitivity.

The anatomy of the preoperative proximal aortic neck was evaluated using 3D-CT angiography reconstructed images in: a) Group I: 15 patients who required secondary procedures and b) Group II: 18 patients without any endovascular leak during follow up.

But the issues of relevance depending on a) the adequacy of the procedures and b) the decisions in the phases of Sense Making and Setting Priorities for reaching the interests of the target group or customer remain biased: One can try to provide objectivity by transformative criticism and one can try to reveal the contextual values that may impede the results.

Each BMSS solution resulting (a) either from the alkaline, autoclave or mild extraction procedures, and (b) either directly from extraction or from the dissolution in water of the solid products, was mixed with both Novex® Tris Glycine sample preparation reagent and NuPAGE® sample reducing agent, and heated at 85 °C for 2 min.

As for "risk management" -- supposedly the strength of Harrison's successor Jamie Dimon -- the bank reportedly could lose as much as $9 billion in "London Whale" losses from a unit that a) Had not been following the bank's highly publicized risk management procedures and b) reported directly to Dimon.

Table 2 shows the local significance levels for both (A) the closed weighted Bonferroni test procedure and (B) the closed weighted parametric test procedure, assuming α=0.025 and equal group sample sizes.

The total deviation W of a system is given by summing all possible quartets of o, a, b, and i. W = ∑iWi = ∑i ∑o, a, b Vo, a, b, i.     (3) Our core set approach is achieved by an iteration of the following two procedures (a) and (b): The first procedure identifies the sequence that gives the largest deviation (Wi value in Eq. (3)), and then excludes it.

The MBR sludge was characterized using the same procedures (a and b).

In ASTM C1611, two filling procedures (A and B) pertaining to two different orientations of the slump cone are permitted.

In the procedures A and B, ethanol and isopropanol were respectively employed as the solvents of TBOT and were remained all through the hydrothermal crystallization of TS-1.

The results indicate no significant differences between procedures A and B with SOPS in all maturation stages, reaching a maximum maturation rate of 21%.