Sentence examples for procedure was dissolved from inspiring English sources

Tris-1,3,5-[ω(2′- O -methyluridine-3′-succinyloxyloxy)octa(ethylene glycol -α-oxymethyl]benzene (4): The crude tris(Dmtr-mU) homostar 3 (4.438 glycol -α-oxymethyl]benzene was dissolved in CH2Cl2 (40 mL) and pyrrole (1.39 mL, 19.6 mmol) was added.

In the typical procedure, NaH2PO4·2H2O (0.0070 g) was dissolved into 100 ml of water.

In a typical procedure, Ce(NO3 3·6H2O was dissolved in double-distilled water and the resulting clear solution was transferred to round bottom flask.

The imine mixture (0.25 mmol imine content, either crude or purified according to the procedure outlined above) was dissolved in MeOH (1 mL) and a 1 m aqueous solution of HCl (1 mL) was added dropwise.

As a final step for both procedures, the zeolite was dissolved in hydrofluoric acid.

In a typical procedure, 3.6 g urea was dissolved in 200 mL of 1.46 mmol L−1 HAuCl4 solution at room temperature.

In a typical procedure, 180 mg SDS was dissolved into 45 ml deionized water under magnetic stirring for more than 20 min to form a stable micellar solution.

In this procedure, ammonium tetrathiotungstate ((NH4 2WS4) was dissolved in dimethylformamide at a high concentration ratio (200 mg mL−1) to obtain a homogeneous solution and then spin-coated onto the indium thin oxide (ITO) substrate for use as a working electrode.

In a typical procedure, BPY (0.2 mmol) was dissolved in TFE in a Schlenk flask and degassed by three "freeze-pump-thaw" cycles to remove oxygen.

To ensure molecular level mixing of DAs and to preclude possible preassembled structures, the CAMs were prepared using the following procedure: first, each molecule was dissolved in hexafluoroisopropanol (HFIP a solvent that is disruptive toward the formation of assembled structures for all the studied molecules.

The 6FDA 6FpDA 4ABA COOH film was prepared using the following procedure: 0.5 g of 6FDA 6FpDA 4ABA COOH was dissolved in 5 ml of DMAc while being stirred.