Sentence examples for procedure of static from inspiring English sources

The procedure of static content-oriented network slicing is completed by the static strategy unit in the MBS controller.

The detailed procedure of static content-oriented network slicing is as follows: Step 1: The state information collection and analysis sub-module collects and analyzes the state information in CNSC-RAN and computes the selected metrics of network performance and/or quality of content service periodically.

A procedure of static compression test was set up primarily including 4 steps as follows: step 1: the compression load was increased from 0 to 180 N in 2 seconds; step 2: the compression load was kept at 180 N for 5 minutes; step 3: the compression load decreased to 10 N in 2 seconds; and step 4: the compression load was kept at 10 N for 5 minutes).

The procedure consists of static calibration by comparison, dynamic evaluation by means of generated sine signals and testing for functionality using of a simple psychophysiological experiment.

The following flowchart (Fig. 4) sketches, for a better comprehension, the procedure of the static strength assessment that has been described.

Section 3 describes the procedure for static adjustment of mobility parameters for traffic steering purposes.

Rolling element (or antifriction) bearings, as applied to centrifugal pumps, have a life expectancy governed by five basic conditions the selection of the correct design of bearing for the service; the quality of lubrication; the correct assembly and maintenance procedures; the degree of static loading imposed on the bearing; and the degree of dynamic loading imposed on the bearing.

Its objectives are to quantify the relative importance of the accidental ultimate limit state of failure of a stay in the design of the bridge, and to determine the safety level provided by the simplified procedure of using a static analysis with a D.A.F. of 2.0.

Many procedures reveal the usage of static VAR compensators and flexible ac transmission systems (FACTS) for the congestion management problem.

Today, it is common to use design procedures based on assumption of static loading only, and dynamic loading is rarely assumed and applied in design and certification of aerospace structures.

The PET/CT acquisition protocol consisted of a dual phase procedure: a static acquisition of the pelvis obtained immediately after tracer injection (1 bed position of 4 min) followed by a whole body scan 60 minutes after injection from the base of the skull to the superior portion of the thighs (6-7 bed positions, 3 minutes per bed) with patient positioned supine with arms crossed above head.