Sentence examples for prism in order to from inspiring English sources

With these approaches, much attention has been paid to analyses of the stress magnitude and orientation in the Nankai accretionary prism in order to understand the processes of interseismic stress accumulation (e.g., Kinoshita and Tobin, [2013]) caused by plate convergence that result in the Nankai megaearthquakes.

This is similar to the multispectral confocal mode except that a grating is used rather than a prism in order to achieve the necessary spectral dispersion.

In "New theory about light and colors", published in the Philosophical Transactions in 1672, Newton presented a number of experiments in which sunlight was allowed to pass through one or two prisms in order to probe some of its basic features.

The design originally included plans to clad the base in glass prisms in order to address criticism that the building might have looked uninviting and resembled a "concrete bunker".

A schematic of a coagulation pathway was inscribed inside a prism phase diagram in order to comprehensively illustrate the formation of genistein modified PA PVP membranes through the solvent/non-solvent exchange process followed by drying.

A parametric study investigating crack widths and patterns in reinforced concrete prisms is presented in order to establish limits to the service-load steel stress and strain.

Purified PCR products were sequenced on the ABI PRISM 3130 XL Genetic Analyzer Appliedd Biosystems, Hitachi) in order to identify loci with nucleotide sequence polymorphisms.

Analyses were carried out using Dynamo SYBR Green kit (Finnzymes) and ABI Prism 7700 (Amersham-Pharmacia) In order to quantify mRNA expression, real time PCR (Q-PCR) was carried out.

PCR conditions were an initial denaturation step at 95°C for 5 min, 30 cycles at 95°C for 30 sec, 56°C for 30 sec and 72°C for 30 sec, with a final extension step at 72°C for 10 min. The size of the amplified fragments was confirmed by capillary electrophoresis on an ABI Prism 310 Genetic Analyzer in order to test whether the isolated peak showed the expected size.

Specimens were cast as 100 × 100 × 100 mm cubes (according to BS: 1881: part 116: 1983) for measuring the change of compressive strength and capillary water absorption and as 75 × 75 × 285 mm concrete prisms (according to ASTM C 490) in order to measure the expansion.

To measure rates of expansion, 75 × 75 × 285 mm concrete prisms were prepared, exposed in sulfate solution and measured (One reference prism was exposed in pure water in order to compare the measurements).