Sentence examples for previous fitting from inspiring English sources
This new method provides substantially better fits than the previous fitting routine.
The following geometry parameters are slightly different from those we used previously [54], as these are taken directly from human vastus lateralis histological data, without the previous fitting requirements to match water spaces (1.4% vascular space and 7% interstitial fluid), nor previous adjustments based on theoretical oxygen consumptions.
To extend our previous fitting results [ 20], two in vitro kinetic datasets were fitted to models of the yeast Grx system (Table 1, [ 26]) and in both cases, good fits of the data were obtained (r≥0.94, Figure 3).
The initial face scaling is estimated via the skin mask's width on the previous fitting ellipsis' minor axis direction.
The weighted standard deviation of 0.94 obtained here for a joint fit of rotational lines belonging to the ground, the lower torsional fundamental, and the higher torsional fundamental states of acetone represents significant progress in comparison with previous fitting attempts, especially for the excited torsional states.
It should be noted that as it happened with the previous fitting results, also in this case Model 2 has a Hill coefficient smaller than unity (h2 = 0.126).
Thus, the radius of the previous fitted circle from the femoral canal centerline could be considered the RFC.
Therefore, results are not presented bCompared to the previous fitted model aFit of model iii was not significantly better than the previous one.
Therefore, results are not presented bCompared to the previous fitted model In men, the between-center CV in potassium biases was initially 8.9% (Model i), which was about 5% of the total variance (Table 5).
Therefore, results are not presented bCompared to the previous fitted model In this paper, we investigated the variation in group-level bias in self-reported protein and potassium intake collected with the computerized 24-h recall (EPIC-Soft) across European adult populations.
The approximation quality of the surface is then progressively improved by adaptively adding more knots onto the parametric domain according to the fitting errors obtained in the previous fit procedure and updating the feature-sensitive configurations.
