Sentence examples for pressure specimen from inspiring English sources

Tests were performed by applying increments of confining pressure, temperature or pore pressure on the rock specimen, and measuring the changes in confining pressure, specimen volume and pore pressure.

The effects of ambient air pressure, specimen width and inclination angle on the burning rate (as determined by mass loss), average flame spreading velocity, flame temperature and flame length were examined.

The vibration compaction test method was used to determine optimum water content and maximum dry density, and cast specimens were analyzed through the vibration pressure producing specimen method.

It is found that increasing the amount of corner strengthening leads to an increase in the confinement effectiveness of CFFTs and results in a more uniform confining pressure distribution along specimen cross-section.

The cylinder surface was covered by extended knitted specimens, with the interfacial pressure between specimen and cylinder recorded at the center marked location of the circumferential line.

Lourenço et al. [12] observed three variations of the HCT response during the initial pore-water pressure measurement before it reaches equilibrium which are equilibrium types A, B and C. Equilibrium type A is the normal equilibrium which is desired where the negative pore-water pressure reaches the negative pore-water pressure of the soil specimen slowly.

Open image in new window Fig. 8 Clothing pressure on Specimen knit structure.

b Elastic recovery (1 h) and clothing pressure on Specimen knit structure.

Open image in new window Fig. 6 Stretch and clothing pressure on Specimen knit structure.

Open image in new window Fig. 7 a Elastic recovery (60 s) and clothing pressure on Specimen knit structure.

However, with increased hydrostatic pressure, the specimen would remain in the compression state, even under sufficient gas adsorption.