Sentence examples for pressure proposed from inspiring English sources
The concept and calculation of fracture gradient probably first came from the minimum injection pressure proposed by Hubbert and Willis (1957).
The sub-grid model for the particle pressure proposed by Igci et al. (2008) is modified by replacing the minimum fluidization velocity.
It can be seen that the original pressure is not so different for genuine and forgery, but the area pressure and motion pressure proposed here are different for genuine and forgery because it is considered that the area pressure can characterize the information about the change of the shape and the pressure during signing process.
These would force the nucleus to become a better separator in dealing with selective pressures proposed by several hypotheses: invasion of introns [ 112], differing metabolisms [ 113] and ribosome chimerism [ 114].
A third order polynomial correlation for prediction of under-saturated oil viscosity as a function of bubble point viscosity, pressure differential (pressure minus bubble point pressure) and pressure ratio (pressure divided by bubble point pressure) was proposed.
As shown in Fig. 8b describing the output signal (V out + − V out − ) versus pressure, the proposed sensor is quite linear in the pressure range from 100 to 400 kPa.
In the solution, a pseudo extrusion pressure was proposed to emulate the effect of the closed ends of the pressure vessel.
The pore pressure model proposed is based on assumption of a reciprocal relationship between strain, stiffness, and pore pressure.
The pressure drop in hollow fibers is formulated by an elliptic integral function, and the effectiveness factor of the transmembrane pressure is proposed to characterize the effect.
Under pressure, Bill Clinton proposed ceding the base as soon as an alternative could be found in a less crowded place.
He said the government needed to "slow down those cuts to give the companies the best chance of continuing to build cars until their announced cease dates" because of the pressure the proposed cuts would put on the big companies and smaller components makers.
