Sentence examples for pressure path from inspiring English sources

Sheet hydroforming process is of concern to eliminate this defect, but the analytical prediction of a proper liquid pressure path is far from perfection.

Results show that the EM2C database is the most accurate for methane over the entire range of the temperature and the fuel partial pressure path length considered.

To this end, linear interpolation for temperature scaling and logarithmic interpolation for pressure and pressure path length scaling are included in the Supplementary material.

The results indicate that the presence of biomedical instrumentation sensors had a statistically significant impact on the centre of pressure path length and ellipse area as well as on the perceived difficulty of the task and its pleasantness.

The design of tube hydroforming operations is mainly aimed to prevent bursting or buckling occurrence and such issues can be pursued only if a proper control of both material feeding history and internal pressure path during the process is performed.

The new charts allow for calculating the water vapor emissivities at homogeneous pathways up to 200 bar equivalent pressure, in the 450 3000 K temperature range and in the 0.01 3000 bar cm pressure path length range; a departure from the original Hottel's emissivity values can be larger than 300% at high pressures.

Furthermore, different D/H values for different fluid densities again reflect the concentration and type of Q n species because the different density trajectories reflect pressure/temperature trajectories of the diamond cell experiments that followed different pressure paths (Mysen 2013).

The above result demonstrates the equivalence of the temperature and pressure paths for approaching a glassy state.

Two common ways of specifying the path are either the constant-pressure path or the constant-volume path.

A wide range of temperatures, pressure-path length products and molar fraction ratios have been covered in the database.

The results suggested that in order to prevent the initiation of forming-defects and to achieve high-quality products, the counter-pressure paths should be designed to match the component-forms to be produced.