"pressure inlet" is a correct and usable phrase in written English.
You can use it when referring to a situation where something, such as air, is taken in under pressure. For example, "The diver's air tank was connected to the pressure inlet so he would have enough air underwater."
The instrument is enclosed in a case that is connected to the outside of the aircraft by an air pressure inlet at the rear of the housing.
System pressure, inlet subcooling, chimney length, orificing diameter and the heat section length are analyzed.
Factors considered were: inlet pressure, inlet temperature, pressure ratio, rotational speed and the mass flow rate.
Total pressure, inlet mole fraction ethene, mass flow rate and wall temperature were varied.
The spray drying was performed at the pressure, inlet and outlet temperatures of 552 Kpa, 160°C and 80 85°C, respectively.
The effect of various parameters such as inlet pressure, inlet temperature, sub-cooling degree, and geometric dimensions are studied.
Equations are derived that describe the gas-dynamic flow through three types of high pressure inlets into a vacuum system: (1) a sonic orifice inlet, (2) a sonic capillary inlet and (3) a pulsed sonic capillary inlet.
Here, we report studies in which the atmospheric pressure inlets of two mass spectrometers were modified to allow matrix/analyte sample to be ablated at reduced pressure.
Major parts of a positive displacement pump are crank-shaft; pump head with low-pressure inlet valves and high-pressure outlet valves; high-pressure plunger conversion set; and pressure regulator valves.
Then, analysis of pressure difference under different static pressures, inlet velocities and different orifice diameters are carried out.
Exponential losses of secondary side pressures (inlet and outlet) are considered for FLB, whereas an exponential loss of primary flow rate is considered for LOFA.
