Sentence examples for prescribed value of from inspiring English sources

Design maps for the penetration resistance of cross-ply composites were constructed using these models and subsequently used to infer composite designs that maximise the penetration resistance for a user prescribed value of fibre strength.

This shows that, in order to maximize (or equivalently, minimize L) for a given V > 0, it suffices to consider distributions supported on the two-point set {0, wmax} and having the prescribed value of V.

Once the steady flame structure is obtained for a prescribed value of the initial Damköhler number, transient evolution of the flame is calculated after a finite amount of the Damköhler-number perturbation is imposed on the steady flame.

To enhance the robustness, a PD like fuzzy controller tunes the cost function weights directly for the game theoretic solution and helps to achieve a prescribed value of cost function components.

These CF tests were strain-controlled during the cyclic part of the stress strain hysteresis loop and then load controlled when the stress was maintained at its maximum value to produce a prescribed value of the creep strain before cyclic deformation was returned under strain-controlled conditions.

As illustrated in Figure 4, θ decreases continuously as η evolves for any prescribed value of ϕ.

For prescribed values of inlet and exit temperatures, the Reynolds number of the flow, coefficient of thermal expansion, gas emissivity and absorptivity and thermal conductivity of the material have about the same impact on the hoop stress.

Additional horizontal and vertical electrodes, respectively of length (L_mathrm{h}) and (L_mathrm{v}), may be added to the ground system in order to obtain prescribed values of the ground resistance.

We apply this to the generalized gradient, with respect to a coefficient in an elliptic operator, of(i) the gap between the operator′s first two eigenvalues and (ii) the distance from a prescribed value to the spectrum of the operator.

Membrane incompressibility is handled by using two penalization parameters per suspended entity: one for deviation of the global area from prescribed value and another for the sum of squares of local strains defined on each vertex.

This paper presents an exact method for obtaining column's designs with the maximum possible critical buckling load while maintaining the total structural mass at prescribed value equal to that of a known baseline design.