Sentence examples for prediction of contact from inspiring English sources

Comparing experimental and predicted values indicated the poor capability of simple DLVO model in prediction of contact angle.

We believe that while both behaviors, communication, and collocation are fairly interchangeable when it comes to prediction of contact formation in the nomination layer, they are not necessarily synchronized and one might precede the other.

The major finding of the paper concerns the prediction of contact discontinuities at the microscopic scale on the tool rake face and where the wear process is highly localized.

The main findings concern the prediction of contact discontinuities and where the wear is highly localised as well as thermomechanical conditions causing observed phenomena, like adhesion of the workmaterial on some zones on the rake face.

The study of mass flux is useful because it is the term common to all conservation equations and the numerical diffusivity introduced in it bears a direct consequence to the prediction of contact (stationary and moving) discontinuities, which are considered to be the limiting case of the boundary layer.

Comparing with the solvent accessibility prediction, there are much fewer methods that deal with the prediction of contact number.

When kinematic boundary conditions resulted in close approximations of the model-predicted joint contact force to the applied force, variations in predictions of contact parameters were also reduced.

The predictions of contact length, lintel bending stress and masonry compressive stress are compared with an approximate solution.

Friction coefficient decreased across all ranges of sliding speed with increasing applied load, consistent with predictions of contact area scaling non-linearly with applied load and pressure-independent surface shear stresses.

Although two-dimensional methods provide accurate predictions of contact stresses and bolt load distribution in bolted composite joints with multiple bolts, they fail to capture the effect of thickness on the strength prediction.

Using the new hydrophobic model, the prediction error of contact angle can be less than 3% compared with the measured one.