Sentence examples for practical conditions for from inspiring English sources

In this article, we present channel delay profiles based on simulated data regarding the practical conditions for the use of visible light communication (VLC) in automotive applications such as Intelligent Transportation Systems ITSS).

Next, we provide some examples of universally inductive sets and investigate some more practical conditions for set-valued mappings to have fixed point in partially ordered topological spaces, where the continuity condition is not applied to the considered mappings.

pH (3.5 9.5), 0.010 0.028 g of adsorbent and 0.5 6.5 min mixing by sonication is good and practical conditions for well and expected adsorption of MB and CV over concentration range of 3 15 mg L−1.

The lower risk of air integration and the higher amount of acetic acid leads to the recommendation for TS of around 30%, but as the silage with lower moisture showed lower pH probably due to reduced dilution, this should be investigated under practical conditions for future optimization.

We address the theoretical and practical conditions for combining data as well as methodological considerations in the combination of data from multiple studies.

To determine which values could be expected under practical conditions for two detection signals from the same structure, we first compared FISH signals generated by two simultaneously hybridized DNA probes labeled in different colors.

The practical condition for a thin film on a transparent substrate is shown in Figure 3.

It is more important that a practical condition for both (A_{L}=I-L-L^) and (A_{U}=I-U-U^) to be Hermitian positive semidefinite is proposed such that both the SSOR iterative method for any (omegain 0,2)) and the SGS iterative method converge to the unique solution of (1) for any choice of the initial guess (x_{0}).

These zones, depending on the physical parameters of the system, can occur for practical conditions of operation.

Practical conditions required for the separation of the contributions of the different layers are analyzed.

According to measurements with small cantilevers, the tip sample contact induces phase advances by ∼11° under the practical conditions used for noninvasive imaging of proteins.