Sentence examples for ppm was shown from inspiring English sources

Nonetheless, CO (250 ppm) was shown in our experiments to reproducibly disrupt IκBα phosphorylation and degradation, and subsequent NF-κB activation in LPS-stimulated human monocytes.

In this study, a low concentration of CO (250 ppm) was shown to inhibit osteoclastogenesis in RANKL-treated RAW264.7 cells.

In other studies, reducing the fuel sulfur content from 1473 ppm to 47 ppm was shown to result in an appreciable reduction of total hydrocarbon emissions from a diesel-powered vehicle tested under a full range of load conditions (Tan et al., 2009).

The lowest phosphorous concentration (14314 ppm) was showed by Lablab niger.

The decreasing CO concentrations, from 200 to 12.5 ppm, are shown by the dashed red line.

Fungal growth recorded for wheat samples treated with essential oils to a level of 1000 ppm is shown in Figure 3.

The times indicated (0, 30 and 60 min) represent the beginning of the spectral data acquisition, and peaks assigned to the α- (around 5.2 ppm) and β-anomers (around 4.6 ppm) are shown.

Plots of saturated current values and response time constants as a function of hydrogen concentration in the range of 1 to 1,000 ppm are shown in Figure 9 for the four kinds of Schottky diodes.

The sensor response here is defined as the ratio of the sensor current change (I gas − I air) after exposure to Cl2 gas with respect to its initial value in air (I air): Response ( left[%right]=frac{I_{mathrm{gas}}-{I}_{mathrm{air}}}{I_{mathrm{air}}}times 100. ) The sensor response of the Ni-Si NW sensor to Cl2 gas of 5 and 20 ppm is shown in Figure 5c.

NO2 concentrations in ppm are shown in the figure (right hand side) for the different NOin.

The highlighted region of this spectrum 50-400 ppm) is shown in Fig. 3B, comprising representative spectra from the three experimental groups acquired at the 5-hour experimental time point, showing the [2-C]-glycine and C-GSH resonances.