Sentence examples for power of plasma from inspiring English sources
By increasing the power of plasma, this phenomenon was more significant.
The structural modification of the plasma torch can increase the power of plasma, which leads to more hardness of the coatings [5].
By adding helium or hydrogen gas to plasma gas, the power of plasma increases resulting in increase of coating hardness [6].
The low pressure of reactive gas and appropriate power of plasma discharge during the deposition assumed pseudoepitaxial conditions of the layer growth.
Effects of some important functionalization parameters, i.e. time and power of plasma applied and concentration of chitosan on the adsorption affinity of the functionalized membrane were investigated and optimum fabrication conditions were determined statistically by Taguchi method.
b The picture of the APS device during deposition Table 1 The parameters of spray Power of plasma, 18 kW Plasma gas flow rate (argon), 25 l/min Gas pressure, 0.3 MPa Powder feed gas flow rate (argon), 15 l/min Stand-off distances, 150, 175, 200 and 225 mm Cooling water rate, 10 l/min Substrate temperature, room temperature.
The synergism of La2O3/γ-Al2O3 La2O3/γ-Al2O3ve methand conversion of 24.9% and C2 hydrocarbons yield of 18.1% were obtained at the plasmainput of plasma was 30 W.
KTM tokamak is planned in order to investigate the following issues: (1) Plasma confinement in tokamak with A=2, plasma parameters and configurations working window; (2) Differed kinds of divertor plates under power flux of plasma to divertor volume; (3) Plasma-wall interaction (different materials and coating) and plasma-limiter configurations.
Spectra which were calculated for three intervals from 10 10, 11 25, and 12 20 have the major peak at 3.5 mHz. Figure 5(a) and (b) show power spectra of plasma flow and magnetic field observed by GTL in the intervals from 13:50, and corresponding spectra at ground stations, and at GOES 8 on synchronous orbit.
Parallel crystallization of anatase and rutile is observed during the process of the plasma treatment; the proportions change as the power of the plasma and treatment time is increased.
The total pressure and power of the plasma are 0.5 Torr and 5 W, respectively.
