Sentence examples for power generation efficiencies from inspiring English sources
There have been few demonstrations that grain boundary engineering results in higher power generation efficiencies despite serious interest in using the strategy to improve zT.
The fuel cell can run on a variety of hydrocarbon fuels or alcohols, and it is possible to reform such fuels within the stack resulting in high power generation efficiencies of around 50% lower heating value.
And when the solar irradiation is larger than 700 W/m2, and water temperature of 13 °C, the maximum instantaneous electrical power output was found to be 0.659 W at the load resistance 4.2 Ω, and the power generation efficiency of the thermoelectric generator (TEG) is 1.956%, which is close to that of a low temperature organic Rankine cycle system.
Higher power generation efficiency means less amount of fuel is used to generate the rated power which will result in better economics and reduced formation of green house gases (Kristiansen 1996).
Owing to the introduction of biomass input in the proposed system, the power generation efficiency is insensitive to solar radiations and times, and thus an efficient and stable utilization approach of solar energy and biomass is achieved at all work conditions.
To optimize the daily performance of solar thermoelectric generator under real meteorological conditions, the daily power generation and daily power generation efficiency are discussed, and approaches obtaining the optimal daily performance are proposed.
Owing to the introduction of a the solar thermochemical energy storage in the proposed system, the power generation efficiency is insensitive to the variations of the solar radiation, and thus an efficient and stable utilization approach of the solar thermal energy is achieved at all work condition.
The solar cells have a power generation efficiency of 7 to 8%.
The power generation efficiency per unit mass of Pt became 33 W g−1.
The estimated power generation efficiency is 0.25 and heat recovery efficiency is 0.65.
Increasing power generation from a BGFC system decreases its power generation efficiency (69 63%), while increasing CHP generation efficiency (80 85%).
