The four factors included chamber pressure, bottom power, flow rate ratio of HBr to He, and flow rate of He O2.
Thermal hydraulic coupling between power, flow rate and density, intensified by neutronics feedback are the main drivers determining the stability behavior of a boiling water reactor (BWR).
ICP etching conditions, including the radio-frequency (RF) power, flow rate of Ar gas, and etching time, were carefully adjusted in an SiCl4 plasma to obtain the desire antireflective Si nanostructures.
Its main feature, flexibility, allows MGT testing in nearly all the conditions that final use may entail, in particular simulation of operating conditions and thermal loads in broadly different electrical power, flow rate and temperature conditions of the cogeneration circuit.
The equation given below describes the relationship between the pump speed, power, flow rate, and pressure difference across the pump (Economides et al. 1994): h_{text{g}} = frac{ 1}{{({{uprho}}_{text{l}} - {{uprho}}_{text{g}} ),g}}left( {frac{text{RPM}}{{C times q_{text{l}} }}, +, P_{text{c}} } right) (26 where C is a constant and ql is the liquid production rate.
The effects that various operating parameters (discharge power, flow rate and initial concentration of acetone) and the interactions between these parameters had on the performance of the plasma-catalytic removal of acetone over the 5.0 wt% CuO/γ-Al2O3 catalyst were investigated using central composite design (CCD).
The optical band gap energy derived by Tauc's equation decays with increasing substrate negative dc bias, ECR-power, flow rate ratio of N2/C2H2, nitrogen to carbon ratio (N/C) determined by X-ray photoelectron spectroscopy (XPS) and with the increase of graphitic content was examined by Raman spectroscopy.
The nature/shape of power-flow rate characteristic curves is also dependent on the specific speed of the pump.
First, the system parameters as net power, mass flow rate, pumps total power consumption, total evaporator exergy inlet, thermal efficiency and exergy efficiency are improved by changing turbine inlet temperature and pressure.
Fig. 10 Pumping power versus flow rate.
Fig. 9 Thermal power versus flow rate.
