Sentence examples for power current density from inspiring English sources

It is common to design gradient coils in terms of a continuous minimum power current density and to perform a discretization to obtain the locations of the coil tracks or wires.

We found that at 10 K and under forward bias, the in-phase component of both electroluminescence detected magnetic resonance (ELDMR) and current detected magnetic resonance (CDMR) responses are positive at low microwave modulation frequency, f; but both reverse sign at a frequency f0 that depends on the microwave power, current density, and device architecture.

The discrete device has a measured power and current density of 18 mW/cm2 and 90 mA/cm2, respectively, into 200 TΩ.

The influence of ultrasonic irradiation on the layer properties was investigated using different combinations of ultrasonic power and current density.

The peak power density, current density and open circuit voltage of Fe-AAPyr-G-1 in 1 M methanol at 80 °C are 2.78 mW cm−2, 19.1 mA cm−2 and 0.7 V respectively.

The as-fabricated V3+/Fe3+ redox microbattery shows very attractive performance such as rechargeability, very high power and current density, low cost and simplicity of fabrication.

Moreover, increasing the anode electrode thickness of an open air cathode MFC from 1.5 to 7.5 cm, resulted in a lowering of the power and current density.

It was found that as the number of bifurcation levels increases, a larger active area can be utilized in order to generate higher power and current densities from the fuel cell with a negligible increase in pumping power.

They exhibit high conversion efficiency to generate minimum amount of heat and be highly reliable, even though the power and current densities are pushed to their physical limits.

Variations in the width, height, and length of the channel with and without tapered electrodes are tested in terms of power and current densities.

This study shows that power and current densities can be boosted by systematically decreasing the catholyte resistance (by additions of NaCl or Na2SO4) and dissolved oxygen concentration.