Sentence examples for power consumption coefficient from inspiring English sources
Fresh water production rate, fresh water recovery, cooling capacity, electrical power consumption, coefficient of performance and system economical index are studied at different operating and design parameters.
The effects of R22, R134a and R744 were analyzed in terms of power consumption, coefficient of performance (COP), solar energy input ratio and so on.
A data acquisition system was designed and built to measure the desired predictors of the power consumption and coefficient of performance of the ASHP water heater.
Power consumption, thermal efficiency, coefficient of performance (COP) of the system in various cooling capacities were estimated theoretically by using the data acquired from the experiments performed.
The parameters such as the power consumption and the coefficient of performance (COP) are investigated under various rotating speeds and charged pressures.
The effects of R22, R134a and R744 were analyzed in terms of power consumption, heat capacity, coefficient of performance (COP) and so on.
The application of the artificial neural network was designed to model individually three typical energy parameters: the cooling capacity, the power consumption and the coefficient of performance, as a function of the evaporating temperature and the condensing temperature.
Fractional gas hold-up, Power consumption and mass transfer coefficient have also been measured for both the impeller combinations.
It was found that the model predictions for the working pressures, power consumption, cooling capacity and coefficient of performance (COP) showed maximum deviations of ±10%.
Experimental investigations and model calculations of power consumption and heat transfer coefficients from a vessel wall to mixed liquid for ribbon impellers operating in a laminar regime are discussed in the paper.
Correlations reported in the literature for gas phase hold-up, mass transfer coefficient and power consumption under gassed and ungassed conditions are compared and recommendations have been made regarding their suitability for design and scale-up of bioreactors.
