Sentence examples for polishing paper from inspiring English sources

The final polish was carried out using 12,000-mesh Micro-Mesh® polishing paper.

Before starting the measurement, the GCE was cleaned with alumina and polishing paper, tracing a rounded pattern resembling the number "eight," several times.

The thickness of the sections was reduced to approximately 20  μm using 1200-grit sandpaper and subsequently polished using 4000-grit paperhing paper in a microgrinding system (Exact 400CS; Exakt Apparatebau) [ 12].

Slide the glass slide slowly across the polishing paper, keeping it as parallel to the paper as possible; be careful not to apply pressure to the slide, as that will increase the chance for uneven grinding.

We further sectioned the notched block into thin wafers and polished them by using polishing papers with progressively finer grade and finally with 0.3-µm alumina powder.

The specimens are then taken through a series of coarse- to fine-grit sandpaper or polishing papers (e.g., 3M Wetordry 6-pc assorted 1 30-μm aluminum oxide/silicon carbide polishing papers; 3M, St. Paul, Minnesota, USA) and ground down to a minimal thickness (<1 30-μm.

Once the thin sections are mounted and the mountant is dry, grind the thin sections using a series of coarse- to fine-grit sandpaper or polishing papers (e.g., 3M Wetordry 6-pc assorted 1 30-μm aluminum oxide/silicon carbide polishing papers; 3M, St. Paul, Minnesota, USA).

To ensure an even grind, place the polishing papers on a smooth, clean, flat surface and hold the glass slide parallel to the paper with your thumb resting on the edge of the slide, and index and ring fingers equally spaced on the slide.

The working electrode must be cleaned with polish paper and alumina before being used.

Before modification, the glassy carbon electrode (GCE) with a diameter of 3 mm was polished to a mirror finish using polish paper and alumina pastes of 50 70 μm and 30 50 nm, respectively, and then cleaned in an ultrasonic cleaner with acetone, alcohol, and water.

I was writing for Gazeta Wyborcza, a Polish paper in Warsaw, and I got my interview.