Sentence examples for point source measurement from inspiring English sources

Consistent with the point source measurement, best results were obtained with the high-resolution clinical reconstruction followed by the research and the clinical reconstruction.

After calibration, the resolution of the nuclear images and the multimodality co-registration error were evaluated with a different set of point source measurements, to avoid using the same measurements for calibration and evaluation.

As was mentioned earlier, we note that SCOS is a more general and quantitative method compared to similar speckle contrast point source measurements proposed previously [ 8, 9] due to the fact that it is a model based measurement.

They found, through simulations performed using a point source-detection measurement geometry, that the reconstructions performed by solving the non-linear problem using a Newton-type method were more accurate than the reconstructions obtained using linearised forward models and linear regularisation methods.

A plastic cube with edge length of 25 mm was used to hold the Point Source Cube during measurement.

In [11], the authors identified the point source with some point measurement data.

b A picture showing the actual plastic cube and Point Source Cube during a measurement on the KCC SRM.

Our second step was to verify that a NL-GS behaves as point source, enabling the WF measurement inside a sample using our SH WFS.

The measured sensor response curves for each grid position are then normalized by the magnetic moment of the point source used for the measurements.

The most significant difference between both standards is the change of the positions of the point source for spatial resolution measurements.

The LII rBC experiments employ pulsed (~20 ns), high intensity lasers that illuminate a point source or a two-dimensional measurement volume as illustrated in the example shown in Fig.  8 [ 202].