Sentence examples for point of specimen from inspiring English sources
Complicating such discussions was the conflation of 'payment' to research subjects for their time and inconvenience at point of specimen collection with 'benefit'benefit
After the maximum strength point of the specimen, the specimen exhibits serious damage along the primary shear crack in its eastside and severe concrete collapse occurs on the compressed side of the specimen (Fig. 11c); then, the strength decreases to 737.6 kN (79.35% of the maximum strength).
LFA was performed retrospectively with cryopreserved (−80°C) specimens collected before April 2011 and prospectively thereafter with point-of-care specimens.
During fatigue tests, 8-bit (256 grey levels) images and thermal images were acquired and elaborated to relate the hysteresis area and the heat sources, finding the energy of damage in three points of specimens.
The geometry of the specimen and the current stress state at any given point of the specimen affect the velocity of a 'pointer' running along these two curves.
In order to measure the deformation of specimens, deflection was measured at the center of the bottom and at the 1/4 point of the specimen length.
The yield point of the specimen was determined according to the load displacement curve.1000kN, ± 250 mm.
The middle point of the specimen is chosen as the exciting point and two pins are used so that the interference between the two loading directions will be released.
The acceleration of the base is recorded by means of a piezoelectric accelerometer, and the vertical displacement of a suitable point of the specimen is recorded by means of an accurate laser sensor.
The strain field was determined using a home-developed image correlation technique that has allowed us to determine all the strain components at each point of the specimen, even with a non-homogeneous strain field.
Such parameters can be readily evaluated at a point of a specimen or a component undergoing a fatigue test by means of temperature measurements, while controlling or monitoring the thermal boundary conditions of the tests is unnecessary.
