Sentence examples for plate extend from inspiring English sources

The focal mechanisms obtained from our OBS observations showed that trench-normal tensional stresses within the subducting Pacific plate extend to a depth of at least about 30 km or even 35 km below the sea surface, which corresponds to 25 km below the top of the oceanic crust, considering the depth range of the active seismicity (Figure 2c,d).

Marks, D. L., Stack, R. A., Brady, D. J. & van der Gracht, J. Three-dimensional tomography using a cubic-phase plate extended depth-of-field system.

Aerodynamic analysis of the wing of Caudipteryx as a rectangular plate extending laterally from the body during running at an arbitrary angle of inclination in moving air.

Aerodynamic analysis of the wing of Caudipteryx as a rectangular plate extending laterally from the body during horizontal running in still air.

It was the 13th game in which Teixeira has homered from both sides of the plate, extending his major league record.

The drain-side field plate has no effect, but the source field plate extending into the source-drain gap moves the hot-spot away from the source contact edge.

Observations of deformation processes, recorded using long-exposure photography, revealed that during the initial stages of sinkage (a few millimetres), the corresponding disturbance of soil below the plate extended disproportionately further and was cylindrical in form.

The chapter shows that where the use of a longitudinal web stiffener provides only minimal benefit, the use of an additional bottom flange plate extending for a short distance over the support can lead to substantial strength gains.

Its magnitude is diminished due to lower current density in the fabricated device (source barrier approximately 50 meV higher); to a comparatively long source (10 μm); to the presence of an effective field plate; extending 2 μm over the edge of the source contact; and to ample metallic connections to all electrodes for improved heat transport.

This paper presents the numerical results of 6 beam column joint tests using six types of connections: web cleat, fin plate, top and seat with web angles (TSWA) (8 mm thick angle), flush end plate, extended end plate, and TSWA (12 mm thick angle).

The joint types including web cleat, top and seat angle, top and seat with web angle (TSWA) (8 mm angle), fin plate, flush end plate, extended end plate and TSWA(12 mm angle) are studied under the central-column-removal scenario.