Sentence examples for plastic shearing from inspiring English sources
Experimental evaluation of plastic shearing due to cold rolling Zircaloy-4 (Zy4) cladding tubes has been performed.
This characteristic is attributed to the low plastic shearing resistance and the low work hardening properties of the alloys.
It is demonstrated that pre-deformation lowers material strength and triggers enhanced strain fluctuation before sample yielding, leading to highly dispersed plastic shearing in the entire sample.
Our results show that while the critical bending stiffness when the interface starts to slide plastically is proportional to the interfacial shear strength, there is a strong nonlinearity between the rigidity and the applied bending after interfacial plastic shearing.
By means of statistical analysis, the deformation mechanisms taking place in elastic loading and plastic shearing stages during serrated flows on the stress-strain curves for bulk metallic glasses were studied comprehensively.
The purpose of this study is to investigate further the behaviour of cantilever beams subjected to projectile impact at its tip, by considering especially physically real effects such as plastic shearing close to the projectile, shear deformation, and the variation of the shear strain along the length and across the thickness of the beam.
In this work, a high-manganese Fe 23Mn 1.5Al 0.3C Twinning-Induced Plasticity (TWIP) steel was subjected to plastic shear deformation using Equal-Channel atgular Pressing (ECAP) at 300 °C following route BC and additional annealing.
Three-dimensional finite element analysis of a bicrystal using a crystal plasticity constitutive theory was performed to compute the maximum plastic shear strain range Δγpmax in the matrix, at the particle/matrix interface, and at the bicrystal boundary.
Panels with higher aspect ratio showed smaller plastic shear strength.
The model accounts for travelling elastic flexural waves, stationary and travelling plastic hinges, elastic-plastic stretching and plastic shear deformation.
Microcrack nucleation and propagation models based on shear stress and plastic shear strain have been applied.
