Sentence examples for plastic density from inspiring English sources

(a) Using MK as a partial replacement for cement decreased the plastic density of the mixtures.

Using MK as a partial replacement for cement decreased the plastic density of the mixtures.

Given the high carbon content of this type of fly ash, however, it was found that there was a need to increase greatly the amount of foam required to achieve the specified design plastic density.

Fresh properties such as slump, plastic air content and plastic density were measure for each batch of concrete as well as other properties, including hardened density, compressive strength, static elastic modulus, sorptivity, hardened air void distribution and thermal resistance.

The model also allows determining that, with the actual protocol, the maximum plastic density which can be extracted is about 1450 kg·m− 3 whereas the detrimental resuspension, which may occur during the column filling step, is highlighted.

A unique mix-design methodology with eight design steps was empirically-cum-numerically derived for CLCs, based on specifying targeted green or plastic density as primary criterion, which is an unexplored area till date.

From this it can be seen that the plastic densities varied between 2,421 and 2,520 kg/m3.

The results of the plastic densities with respect to the corresponding MK percentages are given in Table 2.

Foamed concrete with plastic densities ranging between 1000 and 1400 kg/m3 and cube strengths from 1 to 10 N/mm2 were tested.

Pooling all samples, mean larval densities in the Danube were 275.3 ± 745.0 individuals per 1000 m−3 and hence lower than mean plastic densities.

The result analysis is based on accumulation of damage indicators such as stress, strain and plastic work density in the solder joints.