Sentence examples for plastic conditions from inspiring English sources

This relation enables the estimation of the A-variation under fully plastic conditions.

The RE modelling technique follows the same approach already consolidated in spot-weld modelling technique, performed both in elastic (Vivio 2009) and elastic plastic conditions (Fanelli and Vivio 2009, 2015).

In the reported work velocities are kept low enough to avoid cracking and thus the study is limited to plastic conditions, even though the technique is applicable also for fracture studies.

Embedded defects were introduced at the oxide surface and at the oxide/substrate interface; the propagation of these defects and the influence of such propagation on scale spallation was analysed under both elastic and elastic plastic conditions.

At each step of the analysis, plastic conditions are checked at the critical (end) sections of the girders and columns, where a thermal mapping with reduced mechanical properties is evaluated in accordance with the 500 °C isotherm method proposed by Eurocode 2, while the behaviour of a HYDB is idealized through the use of a bilinear law provided that buckling is prevented.

Forming and shaping processes may be classified into two broad types those performed on the material in a liquid state and those performed on the material in a solid or plastic condition.

New design methodologies are being developed to allow stocky steel members to attain and exceed the full plastic condition.

In this chapter, it may be concluded that local buckling takes place before the fully plastic condition is satisfied at the cross section where internal forces are most severe.

The asymptotic warping functions are calculated only once initially by solving the extended St. Venant equations under two material conditions: purely elastic condition and fully plastic condition when no material point in the cross-section remains elastic.

Empirical equations to predict the A-term under small-scale yielding to fully-plastic condition were developed using estimation methods developed earlier.

Partially end restrained and fixed base portal modules may be used advantageously to address the plastic compatibility conditions where curvatures change sign.