Sentence examples for plasma intensities from inspiring English sources

All the endogenous plasma intensities in a run were shifted by the sample value constant to make the median of sample representative intensities of the standard protein across all runs equal in order to remove the systematic bias created during sample preparation.

Nano cobalt particle size was smaller when the glow discharge plasma intensity was higher.

In all flour beetles' stages, 100% mortality can be achieved depending on plasma exposure time and plasma intensity.

The spectrometer data was analyzed to determine the composition of the plasma and that the plasma intensity (luminosity) directly corresponds to the Flat Top voltage.

The increase of plasma intensity can also lead to a coagulation of nanoparticles and the formation of much larger microscale spherical features.

This allows a local adjustment of the plasma intensity and the control of the deposition process, e.g., for the improvement of film homogeneity, the local modification of film structures, or the introduction of graded thickness profiles.

Visualization of the gas flow and detection of the plasma intensity demonstrated that optimizing the shielding gas parameters could further reduce the rippling phenomenon by affecting the molten pool surface tension and the pressure differential acting upon the molten pool.

A rod of the coating material is drawn coaxially through substrate body and serves as the target, and a magnetic field is applied to enhance the plasma intensity and to control the deposition process.

Russ et al. [97] managed to overcome the plasma intensity of a 450 A argon jet by using a laser shadowgraph system with a pulsed argon ion laser (1 W at 514.5 nm, with approximately 0.1 ms pulse duration) and an exposure of 1 μs, allowing them to investigate the region close to the nozzle exit.

Based on experience, for a high rate of deposition, the RF power and plasma intensity - which is proportional to the rate of change of the temperature of the nickel heating chamber - must be relatively high, yet the nickel heating chamber temperature is to be maintained well below the boiling point of Zn, so that Zn droplets do not form and deposit on the substrate as metallic zinc.

The onboard software has an Auto Gain Control (AGC) function, which controls the WFC/OFA gain considering the received plasma wave intensities (Matsuda et al. 2018).