Sentence examples for plane to minimize from inspiring English sources
Four-degrees-of-freedom motion (two-translational and two-rotational motion) was obtained by four piezoelectric actuators that were set up on the same plane to minimize the effect of the abbe's offset.
And you want a margin of safety around the plane, to minimize the chance that messages will fall on the wrong side.
A transfer matrix is thus obtained, the configuration of the measurements being schematically described in Figrue 3. Fine spatial sampling was chosen for measurements in the transverse plane because, as recalled in the introduction, antenna arrays for MIMO applications have to be put in this plane to minimize correlation between array elements.
The camera was planed approximately 15 degrees above the perpendicular to the central incisors' plane to minimize specula reflection and burn outs.
Fluorescence images stored in an OMERO database were analyzed in Matlab with the following workflow: each m-by-n z stack (FITC channel) was downloaded into Matlab using the OMERO.matlab toolbox, and the resultant 3D matrix was reshaped into an m-by-n∗z plane to minimize edge effects.
A latency-aware memory plane helps to minimize the embedded memory utilization and addresses the variable storage needs of the pipelined DSP architecture.
This effect dictates a tradeoff in the choice of frame rate, as sufficiently high frame rate is needed to capture speckles in regions with a high v y component, while sufficiently low frame rate is needed to allow for speckles to move a number of pixels in the x- z plane order to minimize digitization noise in the velocity measurement.
In particular, the paper defines the number of CubeSats and the orbital planes required to minimize the revisit time, depending on the application that is the mission objective.
The epitaxial Sm2O3 phase grows on the Nb-doped SrTiO3 substrate with a 45o in-plane rotation to minimize their lattice mismatch, 19– 21 which was also proven by an x-ray diffraction phi-scan.
The numerical results indicate that the PDLC film should be designed with the bipolar droplet axis of symmetry normal to the film plane in order to minimize both the required switching field strength and relaxation time.
For the acquisition of "Tulips" the two lamps have been positioned at approximately with respect to the object plane, so as to minimize the reflections.
