The critical thrust force is analytically derived with the consideration of bending, twisting and mid-plane extension of the delamination zone.
Piezoelectric actuators are usually mounted to the top and bottom surfaces of plates and may induce in-plane extension, bending and localized shear deformations at the structural element.
For the case of transverse bending and in-plane extension of the strips, these decaying state conditions are obtained explicitly for the first time when the mixed edge-data are imposed on the strip edge.
In this paper, a comprehensive vibration model is developed for analysing in-plane and out-of-plane vibration of CANDU fuel endplate rings by taking into consideration the effects of in-plane extension in the circumferential and radial directions, shear, and rotatory inertia.
The effect of in-plane extension-shear coupling on the buckling and postbuckling performance of VAT composite plates is investigated.
The range of motion of both wrists was measured in three planes (extension-flexion, radial-ulnar deviation, pronation and supination) with a goniometer that was placed along the axis of rotation of the wrist joint.
The present approach is applied successfully to the analysis of bifurcation and instabilities in (i) a rectangular block during plane strain extension, (ii) a circular bar during uniaxial extension.
Explicit quasi-convex envelopes are provided, and applied to compute the stiffening response of a specimen tested in plane strain extension experiments (pure shear).
The microstructure evolution in terms of plane alignment, extension and cross-linking can be controlled by adjusting the synthesis conditions, such as growth temperature, N2 fraction in the discharge gas and ion energy.
After FDO at the intertrochanteric area, unexpected varus on the coronal plane and extension on the sagittal plane were observed (Table 3).
In low back pain patients, the lumbar range of motion in the sagittal plane (flexion, extension) will be measured using the Spinal Mouse device (see above) with patients in the standing position.
