The contacts were placed in <110> direction of the crystal (corresponding to the M point direction in k-space) which is also the lateral growth direction of the nanosheets.
No significant differences in the incidence of MCM rates were found between subgroups placed in the direction of the predominant wind blowing from the IP and subgroups of comparison (data not shown).
As illustrated in Fig. 5, the concrete sample was placed in the direction of the diameter at the center of the bearing plates, and two wood straps were placed between the bearing plates and the sample to avoid interface cracking and to apply a distributed load along the length of the disks.
An electronic ruler placed in the direction of the contraction was used to measure the amplitude of the first contraction and of monophasic contractions.
Hassan's body was placed in the direction of Mecca, and hands raised, the men prayed.
The main beam of each NSB is steered towards the desired source and a null is placed in the direction of the interfering source, so each NSB will nullify a different source signal.
But it is noted that, the side-by-side arrangement exhibits larger mutual coupling effects since the antennas are placed in the direction of maximum radiation [11, page 474].
In the lateral view, this K wire is placed in the direction of the posterior talar surface, with the same orientation than the posterior bone trabeculae.
The acoustic emission transducer has been placed in the direction with 180° of the array, launched 800Hz continuous single-frequency signal, simultaneously, the motor boat run from about 10° to about 180° position, tested track time is about 108s.
The acoustic emission transducer has been placed in the direction with 90° of the array, launched 331Hz, 800Hz, 1kHz, 1.5kHz,3kHz continuous single-frequency signal respectively, the DOA has been estimated for receiving data, once per second.
ATR experiments with two monolithic catalysts, Rh1.0Pt1.0Ce10La10/Al2O3 (CAT 1) and Rh1.0Pt1.0Mg4.0Y5.0/CeO2 ZrO2 (CAT 2), sequentially placed in the axial direction of the reformer length were used for full-scale tests.
