Depending on the special application tapes with varying designs may be chosen (filament number, alloy of matrix/sheath, twist pitch, cross-section, filling factor, etc).
In the cases of larger pitch, wire cross sections can be significantly larger and resistances lower than microfabricated conductors.
fin pitch, fin spacing ratio, flow cross section aspect ratio and metrological parameter viz.
The relative effects of the frame cross section and pitch on the free vibration characteristics of the whole structure are discussed.
A comparison of the results from the three rectangular cross section coils, the fixed pitch, the Leifer variable-pitch, and the optimized variable-pitch showed that significant improvements could be made to the B1 homogeneity and sensitivity by variations in the pitch of the coil, gains that were partly masked by a drop in the loaded Q-factors from 87 to 84 and 76, respectively.
The algorithm using the taper of the files, the change in the file pitches length and the files cross section changes.
Control of SiNW diameter, cross section, and array pitch can also be achieved through catalyst-patterning techniques, such as nanosphere lithography [24], interference lithography [25], and block co-polymer lithography [26].
These geometrical parameters include different cross section shapes, twisted pitches, twisted direction and lobed numbers.
This paper deals with the investigation of an improvement of steady pitching moment characteristics on the girder cross section to decrease the torsional displacement under wind loads, and also an improvement of flutter stability.
Figure 3d demonstrates the cross section of a 1-μm-pitch tri-diameter AAM fabricated by a four-step anodization process.
