Sentence examples for pinning experiments from inspiring English sources

In contrast to the pattern observed in liquid cultures, in pinning experiments evidence of a period of poor growth followed by recovery for many strains was less striking (e.g., MDPs for his3∆ est1∆ and chk1∆ estrainsrains, Figure 3B).

In pinning experiments, we grew a minimum of 8, sometimes 56 (for those on plate 15, which contained 24 extra copies of a small number of gene deletions), and in the case of his3∆, 144 independently generated double mutant cultures for a total of 22 passages.

Thus, the strength of pinning used in this experiment is ∼33% of the average population size.

(A – C ) Simulation snapshots obtained without coupling to curvature (g = 0) for the three species of pinning sites used in the experiments: Lo% = 11 ± 2 (A ), Lo% = 59 ± 5 (B ), and Lo% = 78 ± 7 (C ).

For 1% interference-fit, micro-scale fiber damage occurred in local regions around hole during the pin installation experiments, while minimal damage was observed for 0.4% interference-fit.

However, by using pinning sites that weakly attract the Lo phase, our experiments also uncover phenomena that cannot be explained using these simulation models.

Furthermore, the results of finite element simulations were correlated with experiments on pinned join repairs.

In dipping experiments with pinned triple line, evaporation of liquid leads to a more complex hydrodynamic flow at the frontier.

Thus, failure to observe an effect of pinning under controlled laboratory conditions indicates that, at least under conditions similar to the experiment, pinning is expected to be of limited importance in controlling the dynamics of real populations.

As reviewers are not able to pin-point a single experiment that will resolve this issue, and it is only the authors who know how best to present their data, it is unclear how the reviewers should advise the authors on this manuscript.

Controlled reciprocating pin-on-disk experiments imitating the wrist pin-connecting rod interface were performed using a High Pressure Tribometer under unlubricated conditions.