Sentence examples for pin tests from inspiring English sources

The ORNL-19 pin tests are chosen to assess the code's capability.

To assess the development status of this code, benchmark calculations were performed with the ORNL 19 pin tests and EBR-II seven-assembly SLTHEN calculation results.

We lastly show FE models using the pull-out response characterised in single pin tests give excellent predictions of experimental behaviour in multi-pin joints with no additional calibration.

The model used in this code had taken the influence of cross flow into account, both forced and natural circulation can be simulated, to assess the development status of KMC-sub, experimental data from ORNL 19 pin tests (sodium cooled) and CAS 61 rods test (lead bismuth eutectic cooled) are compared to results from the code.

The examination of fuel from the pin tested at 1300 °C showed presence of large number of bubbles; both intragranular as well as intergranular bubbles.

For example, Mitrushina et al. [42] found that, whereas the left-right difference in performance did not vary with the age of the participants in a finger tapping test, the superiority of the dominant hand increased with age in the Pin test, a highly demanding task in terms of visuomotor coordination, attention, and precision of movement.

The IEEE 1149.1 requires that every device contain a test-access port (TAP) with four dedicated input/output (I/O) pins: test-data in (TDI), test-data out (TDO), test clock (TCK), and test-mode select (TMS).

Second, the model was applied to the Oak Ridge 19-pin test, and it was found that the measured outlet temperature distribution could be predicted with a maximum error of 8% (<7 °C).

Whereas S1, S2 and S3 are conserved in all four PINs tested, S4 and S5 are not conserved in PIN2 where the corresponding protein sequence motifs are divergent when compared to PIN1, PIN3, PIN4 and PIN7 and when compared to the strong conservation of the S1 S3 phosphosites in all PINs including PIN2.

The study included halo pin penetration tests on 43 skull samples obtained from eight fetal calves, radial compression tests of 11 skull samples, and histology.

Block success evaluations in regional anesthesia studies are time consuming (repetitive sensible testing of heat and cold, pin prick testing, and motor function measurements every 5 min for at least 60 min) and difficult to establish in prospective cohort evaluations.