Scaffolds were cut into 0.5 × 1 cm pieces, thickness measured then clamped into a tensiometer (BOSE Electroforce Test Instruments, MN) using a 22 N load cell and a ramp test at a rate of 0.5 mm/s.
Immediately after slaughter, liver samples for gene expression analysis were collected, rinsed with sterile RNAse-free water solution, cut into small pieces (thickness of ~0.3 cm), stabilised in RNA Later solution (Qiagen, Hilden, Germany) and subsequently stored at –80°C.
Immediately after slaughter, samples of longissimus lumborum muscle and SAT for gene expression analysis were collected from the right side of carcass at the 5th lumbar vertebra level, rinsed with sterile RNAse-free cold water solution, cut into small pieces (thickness of ~0.3 cm), stabilised in RNA Later solution (Qiagen, Hilden, Germany) and subsequently stored at −80°C.
Aim to use about 1 amp per 0.001 inch (0.025 mm) of the work piece's thickness.
The brain was removed and dehydrated by gradient ethanol, cleared by xylene, embedded in paraffin and cut coronally backward from optic chiasma into pieces of thickness 5 μm, then adhered to the glass slices, and finally stored at 4°C.
You can cut your pieces either thickness.
A small piece (100 μm thickness) from the center portion of the GC muscle was carefully dissected and fixed in 2% paraformaldehyde.
Using flow boiling heat transfer, uniform cooling of a 200 mm-long and 0.3 mm thickness piece of target tissue was possible and simulated in a gelatin solution.
When a piece the right thickness you put the handle on, turn on the kiln, walk out of the studio, put the stew in the oven, give it a stir.
