Sentence examples for phases of the test process from inspiring English sources

The taxonomy presented is aligned with the consideration of risks in all phases of the test process and consists of the top-level classes risk drivers, risk assessment, and risk-based test process.

In general, the authors mention that risk-based testing uses risk re-assessments to steer all phases of the test process to optimize testing efforts and limit risks of the software-based system.

Most of the deficiencies were detected in the pre-analytical phase of the testing process; the first two checklists were used for the evaluation of this phase.

Reliability cannot be achieved in a clinical laboratory through the control of accuracy in the analytical phase of the testing process alone.

Figures 5 and 6 indicate that the test process of uniaxial and triaxial compression can be divided into the compaction phase, linear elastic phase, yield phase and failure phase.

In the last few years much progress has been made in raising the awareness of laboratory medicine professionals about the effectiveness of quality indicators (QIs) in monitoring, and improving upon, performances in the extra-analytical phases of the Total Testing Process (TTP).

Figure 2 illustrates, from the left side, (i) the phase of the generic testing process (i.e. Test Case Design); (ii) two process areas that are related to that phase; (iii) the specific goal related to the first process area; and (iv) the various specific practices related to the specific goal.

Höhn (2011) organised the process areas of TMMi according to their relation to each phase of the generic testing process.

Note that process areas from different TMMi levels may be associated to the same phase of the generic testing process.

The execution of the four phases of a generic testing process yields a substantial amount of information.

However, if interpreted considering the several phases of the sliding process, the test is capable of yielding more realistic information about the interface shear strength such as differentiating interfaces which exhibit the same value of ϕstat50 but different behavior for displacement less than 50 mm.