Sentence examples for phases of loading from inspiring English sources
At 45% of the gait cycle, and 20%and48%8% of the stair-climb cycle, peak stresses were simultaneously experienced on both the medial and lateral compartment, suggesting that these phases of loading warrant particular consideration in any simulation intended to evaluate scaffold performance.
Higher bending values were registered in the starting phases of loading At the footing F8 than at the footing F6, which may be result of different compactness of the soil of these footings.
In MFUR the demand-capacity ratios for groups of elements such as beams, columns, connections, etc., remain constant during all phases of loading, and as such M_{i}^{P} = left( {frac{{V_{i} }}{{V_{m} }}} right)left( {frac{{h_{i}}}{{h_{m} }}} right)left( {frac{{1 - P_{m} /K_{m} h_{m} }}{{1 - P_{i} /K_{i} h_{i} }}} right)M_{m}^{P}.
For comparison between the mechanical strength of CP-Ti screw implants with internal tube-in-tube implant-abutment connections and that of external hexagonal-type connections, all abutments and CP-Ti implants with external hexagonal-type connections were heavily damaged or destroyed in all phases of loading.
The current study's protocol included an evaluation of bone strength after cyclic loading during a monotonic loading to failure to compare the different phases of load-displacement curve between control and cyclic loading conditions.
The classification of crack for each phase of loading allowed the identification of the cracks mode of the beam namely tensile crack and shear crack.
The deflection of specimen with PC-BRS is quite symmetrical as compared to other specimens during initial phase of loading.
If a phase of loading could not be completed the number of cycles that were completed before failure was noted.
The first phase of loading was comprised of two cycles which imposed a force corresponding to 50%% of the theoretical strength of the test specimen.
At the early stage of the second phase of loading, one fully reversed cycle with equal amplitude of 100%% of the yield displacement was applied.
After each phase of loading the separation of the tendon ends was measured using the vernier caliper (Ortiz et al., 2012).
