Spontaneous recovery after the cortical injury was observed to the large extent during the early phase (up to a week) in the grid walk test, whereas that was observed during the late phase in the cylinder test.
Effects of reflect and trap boundary conditions for the particulate phase at the cylinder wall, on heat transfer characteristics of nanofluids are also discussed.
Instead, the so-called pseudo-guide wave number and pseudo-phase speed are introduced as they are well defined in the cone case and simplifies to the wave number and phase speed in the cylinder case respectively.
As explained above, this means that in all systems that undergo a phase transition from the tubular phase to the vesicular phase the orientation of the scaffolds in the tubular phase is perpendicular to the cylinder axis.
The data suggest that either the PS or PEB domains is preferentially elongated in the early stage of elongation, depending on the initial alignment of the cylinder phase.
When fA = 0.4, fB = 0.2, and fC = 0.4 at σ = 0.15, the perpendicular lamellar phase LAM3⊥ is stable, while the perpendicular lamellar phase with cylinder at the interfaces is stable without the coated polymer brush at the surfaces.
These studies demonstrated that although it is possible to cause condensation and phase separation by cooling the cylinder, by allowing the cylinder to rewarm to room temperature for at least 48 hours, preferably in a horizontal orientation, and inverting it three times before use, the cylinder consistently delivered the proper proportions of the component gases as a homogenous mixture.
As to orientational phase transitions in the hexagonal cylinder phase, the simulation results show that the parallel orientation is stable at low shear rate and the perpendicular orientation is stable at high shear rate.
For the case of fA = 0.4, fB = 0.2, and fC = 0.4, the perpendicular lamellar phase with cylinders at the interfaces is stable without the coated polymer brush at the surfaces.
On pre-exposure phase (day 1), the animal was placed inside the cylinder and thereafter the cylinder was fixed between the two chambers.
