Sentence examples for phase of injection from inspiring English sources
An overview of the framework is provided and an application to the design phase of injection molding is illustrated.
Many authors developed models to analyze the thermal phase of Injection Stretch Blowing Moulding (ISBM) technology.
The subsequent phase of injection of the complementary DNA strands of oligonucleotides (in red color) is shown in Fig. 10b.
Two phases can be distinguished: a phase termed reactive during the first 3 days (4320 min) and then, after 7 days of the test (or 10,080 min) indicated by point B in Fig. 14, a phase of injection pressure stabilisation at around a value of 0.15 MPa.
The formation of phase morphology of injection molded HDPE/EVA blends, under the effect of shear stress, has been investigated in detail.
Furthermore, toxicokinetic differences between compounds will become more important when exposed via the aqueous phase instead of injection.
In a dual (or triple) phase injection, the second phase is also subject to such a dead space phenomenon if the injection rate is decreased between phases: contrast material in the injection veins travels no faster than the flow of the second phase of the injection.
During the ejection phase of the injection moulding cycle the parts are mechanically forced to separate from the moulding surfaces, this aspect being more relevant with deep cores.
This paper investigates the effects of cement slurry formulation on the thermomechanical behavior of cement sheath in wells subjected to the first heating phase of steam injection.
Images were obtained with short exposure time and sufficiently high spatial and temporal resolutions which allowed a detailed observation of the early phase of fuel injection from the nozzle orifice to near nozzle region.
The spray momentum flux can be determined by means of the impact force method, which was proved to be completely consistent when the basic measuring hypotheses are fulfilled, i.e. during the steady phase of the injection process.
