Sentence examples for performing displacement control from inspiring English sources
This research resulted in the development of a new method for performing displacement control analysis of distributed loads to obtain the ultimate shear strength of structural components.
A double edge notch tension compression, DEN(T C), specimen to perform displacement controlled creep-fatigue crack growth testing is developed and optimized with the help of finite element and boundary element analyses.
To this purpose, a number of SRP strips were bonded to concrete blocks by a thixotropic organic matrix and the lap joint was subsequently subjected to direct shear tests performed in displacement control.
The monotonic shear-compression tests were performed under displacement control and experimental data have provided information about in-plane behaviour of as-built and FRP strengthened tuff masonry walls.
Tests are performed under displacement control of the machine with a rate of 0.2 mm/min.
The tests were performed under displacement control with a loading speed of 0.1 mm/min; the loading force and elongation were measured.
The experimental tests were performed under displacement control and three types of configurations were tested to achieve different mixed-mode ratios.
The analysis in the lateral direction was performed using displacement control (rather than load control) so that the lateral loads developed at various lateral displacement levels could be evaluated as a percentage of the pile diameter.
Tests must be performed by displacement control of the machine and the crack opening displacement in the notch lips at the level of the alignment of the pulling bars (COD) should be controlled and recorded.
Four specimens, including ITO, polyethersulfone (PES), polyimide (PI), and zinc oxide (ZnO), were prepared as listed in Table 1, and nano-indentation tests for each material were performed under displacement control with maximum displacements from 50 to 500 nm using an MTS nanoindenter XP system with a Berkovich diamond indenter (Eden Prairie, MN, USA).
Testing was performed under displacement control at a rate of 1 mm/s.
