The methodology of the study was based on two parallel approaches: expertise was collected from operators in charge of the control of a continuous industrial line, and experiments were performed on a batch process at laboratory scale.
A dynamic model of a long drill was used to provisionally set a target frequency band (TFB) in which chatter is predominant, and then a verification experiment was performed on a drilling process involved in steam turbine rotor manufacturing.
The TRD analysis is performed on a conventionally processed (CP) and a grain boundary engineered (EM) high purity copper sample that have been subjected to successive anneal procedures to promote grain growth.
In this study, to improve strain tolerance to combined inhibitors (FAP; furfural, acetic acid and phenol), a comparative metabolomic analysis was performed on an adaptation process to figure out the potential biomarkers responsible for strain FAP tolerance (Fig. 1).
Even if the deletion or shifting of spikes in the thinning and shifting model is performed on a rate-modulated mother process, the resulting process would not be equivalent to the AD model or STS model, in which the addition and deletion of spikes and the shifting of spike times are not independent of the signal realization.
Deionized water extractions were performed on a subset of processed ores, soils, and sweep samples to model constituent release into surface waters (Hageman 2007).
In vitro bioaccessibility assessments (IVBA) were performed on a subset of processed ores, soils, and sweep samples to model toxicant bioaccessibility and bioavailability along ingestion exposure pathways (Drexler and Brattin 2007; Morman et al. 2009).
Indirect UHT-processing was performed on a Junior N326L apparatus, Process Pilot Plant, 200 Lh-1 (APV, Aartselaar, Belgium) under the following conditions: 2 steps homogenization: 200 bar, 65 °C; indirect UHT-processing: 5 s,140 °C; cooling to 20 °C.
In this study, stability and bifurcation analyses are performed on a cylindrical traverse grinding process in order to investigate its nonlinear chatter behaviors.
The fabrication is based on an electron-beam direct-writing process performed on a coated 100 nm hydrogen silsesquioxane (HSQ) resist film.
