Sentence examples for percentage of solid from inspiring English sources

In particular, we study the effects of temperature, pressure and catalyst diameter on the methane and CO2 conversions, as well the H2 to CO ratio and the molar percentage of solid carbon deposited on the catalyst.

The Polonite-P chemical equilibrium model predicted that Pb formed a stabilized solid over a wider pH range than Polonite and the percentage of solid Pb4O(PO4)2 increased with increasing initial Pb loading above approximately 65 mg Pb/L.

For cellular foams with plates, the relation of G&A for closed-cell foams applied with different values of φ, which is the percentage of solid only contained in the struts.

For bed materials including high-density polyethylene beads, glass beads, and cork, the percentage of solid concentration in the horizontal crossover pipe connecting the riser exit and the cyclone inlet was found to be 22% of the average concentration of solids in the riser.

The variables in the main operating spray dryer are percentage of solid feed, inlet air temperature, and outlet air temperature.

As expected, the percentage of solid sodium tungsten bronzes nanoparticles in the product was increased with the increase in temperature.

This efficiency was based on the percentage of solids removed, which corresponds to the percentage of solids introduced into the raceway that settle in it, with settling taking place primarily in the quiescent zone.

At the same time the already high percentage of solids in the chemical processes is going to increase.

Settling effectiveness was evaluated on the basis of the percentage of solids removed by settling relative to the mass of solids introduced into the raceway, with solids settling primarily in the quiescent zone (QZ).

The main objective of this work is to assess which from the four selected factors (temperature, tea percentage of solids, pH and amount of EDTA), increase the amount of polyphenols in the black tea clear phase, with minimal cream formation.

These scaffolds were prepared by impregnating a body of porous polyurethane foam with slurry containing HA powder, and using a percentage of solids between 40% and 50% w/v, and three different types of monomers to provide a better performance.