Sentence examples for peak material from inspiring English sources

For two of the parameters, i.e. the texture aspect ratio (Str) and the peak material volume (Vmp) the correlation coefficient was found to be high.

Stepwise regression indicated that the density of peaks (Spd) and the peak material volume (Vmp) best correlate (R2 = 0.75 0.76) with friction, but the Spd is more influential.

At these rates, the optimum operating temperature for this device will be at around 220 K, where the maximum peak material gain coincides with the DBR resonance cavity position.

Figure 3a is an individual sample for the catalyst support, which is F0.1 sample, to look the close-up XRD pattern with all the peak material in TiO2-CNF, while Fig. 3b is the entire flow rate sample involved.

This study examines the relative sensitivity of peak material temperatures within the cask to parameters that influence both the stored fuel residual decay heat as well as heat removal mechanisms.

By examining the factors that drive heat removal from the cask alongside well-understood factors that drive decay heat, it is therefore possible to make a contextual analysis of the most important parameters to evaluation of peak material temperatures within the cask.

This concern is attached to the more brittle post-peak material behaviour and smoother crack surfaces of these concretes compared to normal density concrete (NWC).

Both C and D τ2) are expressed as power series, allowing several typical pre-peak material nonlinearities to be described with reasonable accuracy.

In this research, the post-peak material behaviour and the force transfer across cracks were considered to be unimportant, regardless of the weight of the concrete.

It follows from these features, that the strength, and especially the ductility, of structural concrete members depend on the local triaxial stress conditions that inevitably develop in the compressive zone just prior to failure, rather than on stress-redistributions due to post-peak material characteristics, as is commonly believed.

A 5 mL aliquot was pumped through the reactor (QP-SA, 15 g) at 90 °C with 1 mL min 1 flow rate and the product stream was analysed by TLC, showing a peak of material at 25 30 min and no material eluting before 20 min. A sample of the material was concentrated and analysed by H NMR to show the expected ratio between targeted pyranoses and residual furanoses (ca. 93 7).